SM-10

Technical parameters:

★Heating plate surface by grinding treatment, hot plate width 600mm, a total of 12 heating plate and cooling 4 m。
★Heating
plate with a container board production, in line with national
standards for a class pressure vessel, with pressure vessel···

Product description

※Structural features:

★Heating plate surface by grinding treatment, hot plate width 600mm, a total of 12 heating plate and cooling 4 m。
★Heating plate with a container board production, in line with national standards for a class pressure vessel, with pressure vessel certificate and inspection certificate。
★Hot plate with intensive gravitational roll structure. Roll adopt pneumatic lifting.
★Heating plate heat transfer pipe temperature control sub-four-segment, with a temperature display.
★on cotton use two-cylinder S type cotton belt with the tensioning device.
★lower belt adopt pneumatic tensioning.
★Drive roller coated with attached wear-resistant rubber ,showed a herringbone structure,With a high, ensure smooth cardboard output。
★Main drive motor for frequency conversion motor,low-speed torque,wide speed range ,reliable, and easy maintenance.
★hot plate internal for partition isolation structure,s-shaped flow of steam,Steam, water separation function significantly improves the utilization of steam。

※Technical parameters:

1、temperature requirement:160—200℃   steam pressure:0.8-1.3Mpa
2、air source pressure:0.6—0.9Mpa
3、Cooling stereotypes length:4m       Heating plate quantity:12 pieces
4、hydraulic system pressure:6---8Mpa

※Roller diameter parameters:

1、upper drive rubber roller diameter:¢475mm lower drive rubber roller diameter:¢350mm Wear rubber Outsourcing
2、Former follower with roller diameter:¢176mm back setting belt driven roller diameter:¢176mm
3、Platen roller:¢85mm Setting roller diameter:¢86mm
4、upper belt tension roller diameter:¢155mm upper roll diameter with detuning:¢124mm
5、Lower belt tension roller diameter:¢130mm Entrusted with the roll diameter lower belt:¢130mm
Note: All the roller surface after grinding are hard chrome plated

※Powered motor parameters:

1、Main drive motor power:22KW 380V 50Hz Continuous (S1) working standard

※Mainly purchased parts, raw materials and origin:


m.png

Messages